3.2.8.3 Frame Removal
Step 1:
Remove the engine unit (Refer to section 3.2.8.)
Step 2:
Remove four CB (M3 x 15) screws.
Step 3:
Slide the lens holder block out slowly from the frame.
Screw
Insert the four rubber nuts to the frame, set the lens holder block into the frame, then fix them by
four CB (M3 x 15) screws. Rotate each CB screw until its top comes APPROX. 4 mm out from
the rubber nut.
When set the lens holder block into the frame, there is no cable catch between the lens holder
and the frame.
Rev. A
Rubber Nut
Figure 3-21. Frame and Lens Holder Block Separation
ASSEMBLING POINT
DISASSEMBLY AND ASSEMBLY
Frame
Lens Holder Block
17
3-