Download Print this page

Sub Board Removal (Scsi Model Only) - Epson FilmScan 200 Service Manual

Hide thumbs Also See for FilmScan 200:

Table of Contents

FilmScan 200

3.2.6 Sub Board Removal (SCSI Model Only)

Step 1:

Remove the upper case (Refer to section 3.2.2.)

Step 2:

Loosen the three CB (M3 x 6) screws that fastens on the inverter board (Refer to section

3.2.4. Inverter Board.)

Step 3:

Remove the shield plate C.

Step 4:

Remove the two hexagonal nut-screws.

Step 5:

Remove the FFC cable from the sub board then take the sub board away.

Apply the screw-lock when installing the two hexagonal nut screws.

3-10

FFC

Figure 3-10. Sub Board Removal

ASSEMBLING POINT

Hexagonal

Screw

Rev. A

Table of Contents

Table of Contents