HP A6600 Configuration Manual page 44

# Create Layer 3 aggregate interface Route-Aggregation 2, configure its link aggregation group to
perform load sharing based on destination IP address, and configure an IP address and subnet mask for
the aggregate interface.
[RouterA] interface route-aggregation 2
[RouterA-Route-Aggregation2] link-aggregation load-sharing mode destination-ip
[RouterA-Route-Aggregation2] ip address 192.168.2.1 24
[RouterA-Route-Aggregation2] quit
# Assign Layer 3 Ethernet interfaces GigabitEthernet 4/1/3 and GigabitEthernet 4/1/4 to aggregation
group 2.
[RouterA] interface gigabitethernet 4/1/3
[RouterA-GigabitEthernet4/1/3] port link-aggregation group 2
[RouterA-GigabitEthernet4/1/3] quit
[RouterA] interface gigabitethernet 4/1/4
[RouterA-GigabitEthernet4/1/4] port link-aggregation group 2
[RouterA-GigabitEthernet4/1/4] quit
Configure Router B
2.
Configure Router B using the same instructions that you used to configure Router A.
Verify the configurations
3.
# Display summary information about all aggregation groups on Router A.
[RouterA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG AGG
Interface Mode
-------------------------------------------------------------------------------
RAGG1 S
RAGG2 S
The output shows that link aggregation groups 1 and 2 are both load shared Layer 3 static aggregation
groups and each contains two selected ports.
# Display all group-specific load sharing criteria on Router A.
[RouterA] display link-aggregation load-sharing mode interface
Route-Aggregation1 Load-Sharing Mode:
source-ip address
Partner ID
none
none
37
Select Unselect Share
Ports Ports Type
2 0 Shar
2 0 Shar