Vlan Transparent Transmission Configuration Example - HP A6600 Configuration Manual

# To enable interoperability with the third-party devices in the public network, set the TPID of the service
provider network VLAN tags to 0x8200. The port tags the received frames with the outer VLAN tag
whose TPID is 0x8200.
[PEB-GigabitEthernet2/0/1] qinq ethernet-type service-tag 8200
[PEB-GigabitEthernet2/0/1] quit
Configuration on GigabitEthernet 2/0/2
•
# Configure VLAN 2000 as the default VLAN.
[PEB] interface gigabitethernet 2/0/2
[PEB-GigabitEthernet2/0/2] port access vlan 2000
# Enable basic QinQ. Tag frames from VLAN 20 with the outer VLAN tag 2000.
[PEB-GigabitEthernet2/0/2] qinq enable
[PEB-GigabitEthernet2/0/2] quit
Configuration on GigabitEthernet 2/0/3
•
# Configure VLAN 3000 as the default VLAN.
[PEB] interface gigabitethernet 2/0/3
[PEB-GigabitEthernet2/0/3] port access vlan 3000
# Enable basic QinQ to tag frames of all customer VLANs with the outer VLAN tag 3000.
[PEB-GigabitEthernet2/0/3] qinq enable
Configuration on devices on the public network
3.
Third-party devices are deployed between PE A and PE B. This section describes only the basic
configuration required on the routers. Configure the device connecting to GigabitEthernet 2/0/3 of PE A
and the device connecting to GigabitEthernet 2/0/1 of PE B so that their ports send tagged frames of
VLAN 1000, VLAN 2000, and VLAN 3000. The configuration steps are omitted here.

VLAN transparent transmission configuration example

Network requirements
As shown in
The two branches of a company, Site 1 and Site 2, are connected through the service provider
•
network and uses VLANs 10 through 50.
• PE 1 and PE 2 are edge devices on the service provider network and are connected through
third-party devices with a TPID value of 0x8200.
Configure the edge and third-party devices to allow frames of VLANs 10 through 50 to be
•
transmitted between the branches of the company via the service provider network with no outer
VLAN tags added.
Figure 53:
157