Displaying And Maintaining Super Vlan; Super Vlan Configuration Example - HP A6600 Configuration Manual

Displaying and maintaining super VLAN

To do...
Display the mapping between a
super VLAN and its sub-VLANs

Super VLAN configuration example

Network requirements
As shown in
• Create super VLAN 10, and configure its VLAN interface IP address as 10.0.0.1/24.
• Create the sub-VLANs VLAN 2, VLAN 3, and VLAN 5.
• Assign GigabitEthernet 4/1/1 and GigabitEthernet 4/1/2 to VLAN 2, GigabitEthernet 4/1/3 and
GigabitEthernet 4/1/4 to VLAN 3, and GigabitEthernet 4/1/5 and GigabitEthernet 4/1/6 to
VLAN 5.
The sub-VLANs are isolated at Layer 2 but connected at Layer 3.
•
Figure 36 Network diagram for super-VLAN configuration
GE4/1/1
GE4/1/3
GE4/1/4
GE4/1/5
VLAN 3
Configuration procedure
# Create VLAN 10, and configure its VLAN interface IP address as 10.0.0.1/24.
<Sysname> system-view
[Sysname] vlan 10
[Sysname-vlan10] interface vlan-interface 10
[Sysname-Vlan-interface10] ip address 10.0.0.1 255.255.255.0
# Enable local proxy ARP.
[Sysname-Vlan-interface10] local-proxy-arp enable
[Sysname-Vlan-interface10] quit
# Create VLAN 2, and assign GigabitEthernet 4/1/1 and GigabitEthernet 4/1/2 to it.
[Sysname] vlan 2
[Sysname-vlan2] port gigabitEthernet 4/1/1 gigabitEthernet 4/1/2
[Sysname-vlan2] quit
# Create VLAN 3, and assign GigabitEthernet 4/1/3 and GigabitEthernet 4/1/4 to it.
[Sysname] vlan 3
Figure 36,
VLAN 2
GE4/1/2
Vlan-int10
10.0.0.1/24
GE4/1/6
VLAN 5
Use the command...
display supervlan [ supervlan-id ] [ | { begin
| exclude | include } regular-expression ]
111
Remarks
Available in any
view