HP A6600 Configuration Manual page 27

To do...
3. Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view
4. Configure the aggregation
group to work in dynamic
aggregation mode
5. Exit to system view
6. Enter Layer 2 Ethernet
interface view
7. Assign the Ethernet interface
to the aggregation group
8. Assign the port an
aggregation priority
9. Set the LACP timeout interval
on the port to the short timeout
interval (1 second)
Configuring a Layer 3 dynamic aggregation group
To configure a Layer 3 dynamic aggregation group:
To do...
1. Enter system view
2. Set the system LACP
priority
3. Create a Layer 3
aggregate interface and
enter Layer 3 aggregate
interface view
Use the command...
interface bridge-aggregation
interface-number
link-aggregation mode dynamic
quit
interface interface-type
interface-number
port link-aggregation group
number
link-aggregation port-priority
port-priority
lacp period short
Use the command...
system-view
lacp system-priority
system-priority
interface route-aggregation
interface-number
20
Remarks
Required.
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
Required.
By default, an aggregation group
works in static aggregation mode.
—
Required.
Repeat these two steps to assign
more Layer 2 Ethernet interfaces to
the aggregation group.
Optional.
By default, the aggregation
priority of a port is 32,768.
Changing the aggregation priority
of a port may affect the
aggregation state of the ports in
the dynamic aggregation group.
Optional.
By default, the LACP timeout
interval on a port is the long
timeout interval (30 seconds).
Remarks
—
Optional.
By default, the system LACP priority is
32,768.
Changing the system LACP priority may
affect the aggregation state of the ports
in the dynamic aggregation group.
Required.
When you create a Layer 3 aggregate
interface, the system automatically
creates a Layer 3 static aggregation
group numbered the same.