HP A6600 Configuration Manual page 39

Configuring GigabitEthernet3/1/2... Done.
[RouterA-Bridge-Aggregation1] quit
# Create Layer 2 aggregate interface Bridge-Aggregation 2, and configure the load sharing criterion for
the link aggregation group as the destination MAC addresses of packets.
[RouterA] interface bridge-aggregation 2
[RouterA-Bridge-Aggregation2] link-aggregation load-sharing mode destination-mac
[RouterA-Bridge-Aggregation2] quit
# Assign ports GigabitEthernet 3/1/3 and GigabitEthernet 3/1/4 to link aggregation group 2.
[RouterA] interface gigabitethernet 3/1/3
[RouterA-GigabitEthernet3/1/3] port link-aggregation group 2
[RouterA-GigabitEthernet3/1/3] quit
[RouterA] interface gigabitethernet 3/1/4
[RouterA-GigabitEthernet3/1/4] port link-aggregation group 2
[RouterA-GigabitEthernet3/1/4] quit
# Configure Layer 2 aggregate interface Bridge-Aggregation 2 as a trunk port and assign it to VLANs 10
and 20.
[RouterA] interface bridge-aggregation 2
[RouterA-Bridge-Aggregation2] port link-type trunk
[RouterA-Bridge-Aggregation2] port trunk permit vlan 10 20
Please wait... Done.
Configuring GigabitEthernet3/1/3... Done.
Configuring GigabitEthernet3/1/4... Done.
[RouterA-Bridge-Aggregation2] quit
Configure Router B
2.
Configure Router B using the same instructions that you used to configure Router A.
Verify the configurations
3.
# Display summary information about all aggregation groups on Router A.
[RouterA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG AGG
Interface Mode
-------------------------------------------------------------------------------
BAGG1 S
BAGG2 S
The output shows that link aggregation groups 1 and 2 are both load-sharing-capable Layer 2 static
aggregation groups and each contains two selected ports.
# Display all group-specific load sharing criteria on Router A.
[RouterA] display link-aggregation load-sharing mode interface
Partner ID
none
none
32
Select Unselect Share
Ports Ports Type
2 0 Shar
2 0 Shar