HP A6600 Configuration Manual page 178

Figure 62 Network diagram for unambiguous QinQ termination configuration
Configuration procedure
Configure Host A and Host B.
1.
Configure Host A's IP address as 1.1.1.1/24, and gateway IP address as 1.1.1.11/24.
•
Configure Host B's IP address as 1.1.2.1/24, and gateway IP address as 1.1.2.11/24.
•
Configure Layer 2 Switch A.
2.
<L2_SwitchA> system-view
[L2_SwitchA] vlan 11
[L2_SwitchA-vlan11] port ethernet 1/2
[L2_SwitchA-vlan11] quit
[L2_SwitchA] interface ethernet 1/1
[L2_SwitchA-Ethernet1/1] port link-type trunk
[L2_SwitchA-Ethernet1/1] port trunk permit vlan 11
Please wait... Done.
Configure Layer 2 Switch B.
3.
<L2_SwitchB> system-view
[L2_SwitchB] interface ethernet 1/2
[L2_SwitchB-Ethernet1/2] port link-type trunk
[SwitchB-Ethernet1/2] port trunk permit vlan 11 100
Please wait... Done.
[L2_SwitchB-Ethernet1/2] qinq vid 100
[L2_SwitchB-Ethernet1/2-vid-100] raw-vlan-id inbound 11
[L2_SwitchB-Ethernet1/2-vid-100] quit
[L2_SwitchB-Ethernet1/2] quit
[L2_SwitchB] interface ethernet 1/1
[L2_SwitchB-Ethernet1/1] port link-type trunk
[L2_SwitchB-Ethernet1/1] port trunk permit vlan 100
Please wait... Done.
171