Configuring Ambiguous Dot1Q Termination - HP A6600 Configuration Manual

[L2_SwitchA-Ethernet1/1] port link-type trunk
[L2_SwitchA-Ethernet1/1] port trunk permit vlan 10 20
Please wait... Done.
Configure Layer 2 Switch B as you configure Layer 2 Switch A.
Configure the router.
3.
# Create GigabitEthernet 4/2/1.10, GigabitEthernet 4/2/1.20, GigabitEthernet 4/1/1.10,
GigabitEthernet 4/1/1.20 and enter subinterface view, and then assign IP addresses for them. Configure
GigabitEthernet 4/2/1.10 and GigabitEthernet 4/1/1.10 to terminate packets tagged with VLAN 10,
and configure GigabitEthernet 4/2/1.20 and GigabitEthernet 4/1/1.20 to terminate packets tagged
with VLAN 20.
<Router> system-view
[Router] interface gigabitethernet 4/2/1.10
[Router-GigabitEthernet4/2/1.10] ip address 1.0.0.1 255.0.0.0
[Router-GigabitEthernet4/2/1.10] vlan-type dot1q vid 10
[Router-GigabitEthernet4/2/1.10] quit
[Router] interface gigabitethernet 4/2/1.20
[Router-GigabitEthernet4/2/1.20] ip address 2.0.0.1 255.0.0.0
[Router-GigabitEthernet4/2/1.20] vlan-type dot1q vid 20
[Router-GigabitEthernet4/2/1.20] quit
[Router] interface gigabitethernet 4/1/1.10
[Router-GigabitEthernet4/1/1.10] ip address 3.0.0.1 255.0.0.0
[Router-GigabitEthernet4/1/1.10] vlan-type dot1q vid 10
[Router-GigabitEthernet4/1/1.10] quit
[Router] interface gigabitethernet 4/1/1.20
[Router-GigabitEthernet4/1/1.20] ip address 4.0.0.1 255.0.0.0
[Router-GigabitEthernet4/1/1.20] vlan-type dot1q vid 20
[Router-GigabitEthernet4/1/1.20] quit

Configuring ambiguous Dot1q termination

To configure ambiguous Dot1q termination:
To do...
1. Enter system view
2. Enter
interface
view
3. Enable Dot1q termination on the
subinterface, and configure the subinterface
to terminate the dot1q packets with the
specified VLAN IDs
Enter Layer 3 Ethernet
subinterface view
Enter Layer 3 aggregate
subinterface view
Use the command...
system-view
interface interface-type
interface-number.subnumber
interface route-aggregation
interface-number.subnumber
vlan-type dot1q vid vlan-id-list
167
Remarks
—
Required.
Use either command.
Required.