HP A6600 Configuration Manual page 165

Figure 53 Network diagram for VLAN transparent transmission configuration
Configuration procedure
Make sure that the devices in the service provider network have been configured to allow QinQ packets
to pass through.
Configuration on PE 1
1.
Configure GigabitEthernet 4/1/1.
•
# Configure GigabitEthernet 4/1/1 as a trunk port and assign it to VLANs 10 through 50.
<PE1> system-view
[PE1] interface gigabitethernet 4/1/1
[PE1-GigabitEthernet4/1/1] port link-type trunk
[PE1-GigabitEthernet4/1/1] port trunk permit vlan 10 to 50
# Enable basic QinQ on the port.
[PE1-GigabitEthernet4/1/1] qinq enable
# Configure the port to transparently transmit frames from VLANs 10 through 50.
[PE1-GigabitEthernet4/1/1] qinq transparent-vlan 10 to 50
[PE1-GigabitEthernet4/1/1] quit
Configure GigabitEthernet 4/1/2.
•
# Configure GigabitEthernet 4/1/2 as a trunk port and assign it to VLANs 10 through 50.
[PE1] interface gigabitethernet 4/1/2
[PE1-GigabitEthernet4/1/2] port link-type trunk
[PE1-GigabitEthernet4/1/2] port trunk permit vlan 10 to 50
# Set the TPID value in the outer VLAN tag to 0x8200 on the port.
[PE1-GigabitEthernet4/1/2] qinq ethernet-type 8200
[PE1-GigabitEthernet4/1/2] quit
Configuration on PE 2
2.
Configure GigabitEthernet 4/1/1.
•
# Configure GigabitEthernet 4/1/1 as a trunk port and assign it to VLANs 10 through 50.
<PE2> system-view
[PE2] interface gigabitethernet 4/1/1
[PE2-GigabitEthernet4/1/1] port link-type trunk
158