Deleting BOF Parameters
You can delete specific BOF parameters. The no form of these commands removes the parameter
from configuration. The changes remain in effect only during the current power cycle unless a
command is executed. Changes are lost if the system is powered down or the router is
save
rebooted without saving.
Deleting a BOF address entry is not allowed from a Telnet session.
Use the following CLI syntax to save and remove BOF configuration parameters:
CLI Syntax: bof# save [cflash-id]
Example
7950 SR OS Basic System Configuration Guide
:
A:ALA-1# bof
A:ALA-1>bof# save cf:
A:ALA-1>bof#
Boot Option Files
Page 197