High Availability
CPM Switchover
During a switchover, system control and routing protocol execution are transferred from the active
to the standby CPMAn automatic switchover may occur under the following conditions:
•
•
Online removal of the active CPMA manual switchover can occur under the following conditions:
•
Page 236
A fault condition that causes the active CPM to crash or reboot.
The active CPM is declared down (not responding).
To force a switchover from an active CPM to a standby, use the
command. You can configure a batch file that executes after
force-switchover
failover by using the config system switchover-exec and admin redundancy force-
switchover now CLI commands.
7950 SR OS Basic System Configuration Guide
admin redundancy