Configuring Multi-Chassis Redundancy - Alcatel-Lucent 7950 XRS Series Configuration Manual

Configuring Multi-Chassis Redundancy

Configuring Multi-Chassis Redundancy
Note: When configuring associated LAG ID parameters, the LAG must be in access mode and
LACP must be enabled.
Use the CLI syntax displayed below to configure multi-chassis redundancy features.
CLI Syntax: admin>redundancy
Example
10.10.10.2"
id 00:00:00:33:33:33 system-priority 32888
The following displays the configuration:
A:ALA-48>config>redundancy# info
---------------------------------------------
Page 296
multi-chassis
peer ip-address
authentication-key [authentication-key | hash-key]
[hash | hash2]
description description-string
mc-lag
hold-on-neighbor-failure duration
keep-alive-interval interval
lag lag-id lacp-key admin-key system-id system-id [remote-
no shutdown
no shutdown
source-address ip-address
sync
igmp
igmp-snooping
port [port-id | lag-id] [sync-tag]
no shutdown
srrp
:
admin>redundancy#
config>redundancy# multi-chassis
config>redundancy>multi-chassis# peer 10.10.10.2 create
config>redundancy>multi-chassis>peer# description "Mc-Lag peer
config>redundancy>multi-chassis>peer# mc-lag
config>redundancy>mc>peer>mc-lag# lag 1 lacp-key 32666 system-
config>redundancy>mc>peer>mc-lag# no shutdown
config>redundancy>mc>peer>mc-lag# exit
config>redundancy>multi-chassis>peer# no shutdown
config>redundancy>multi-chassis>peer# exit
config>redundancy>multi-chassis# exit
config>redundancy#
multi-chassis
lag lag-id] system-priority system-priority
range encap-range sync-tag
7950 SR OS Basic System Configuration Guide