Removing The Back Panel & Trays - Jenn-Air JBC7624BS Technical Education

COMPONENT ACCESS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
1. First, perform preparation procedure on page 4-8, "Before
Disassembling the Coffee System" prior to performing the
following steps.
2. Follow the procedures to "Remove Fan Panel" on
preceding page.
3. To gain access to the back panel, remove the accessory
trays. Remove two (2) screws at the back of each
accessory tray as shown in Figure 1.
Right-side
accessory tray
4. Remove two (2) screws from the back panel and one
screw from underneath the tray (see Figure 2 in next
column). Remove both trays from the coffee system.
4-10 Jenn-Air Built-in Coffee System
n
Removing the Back Panel & Trays
Left-side
accessory tray
Figure 1
5. Unscrew three (3) screws (two of them are Torx screws)
from the right side (see Figure 3).
Figure 3
6. Unscrew three (3) screws (two of them are Torx screws)
from the left side (see Figure 4). Remove back panel.
Figure 2
Figure 4