INSTALLATION
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Measuring tape
I
Pencil
I
Level
I
Masking tape
I
Parts Supplied
All of the following parts are provided, but some parts may not be
used. The location of your coffee system installation will
determine which parts you will use.
C
D
A. Mounting brackets/runners (2)
B. Metal trim piece (1)
C. Bracket spacers (4) (2 - 1 mm thick;
2 - 2 mm thick)
D. Power supply cord clip (1)
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Cabinet opening dimensions that are shown must be used.
I
Given dimensions provide minimum clearance with coffee
system.
The built-in coffee system must be installed in cabinetry with
I
the dimensions provided.
Follow the installation instructions for any cabinetry used to
I
house the built-in coffee system. Make sure cabinet is
securely attached to the wall.
Follow the installation instructions
I
Recessed installation area must provide complete enclosure
I
around the recessed portion of the coffee system.
Grounded electrical supply is required. See "Electrical
I
Requirements" section.
†®TORX and T20 are registered trademarks of Saturn Fasteners, Inc.
n
3-2
Jenn-Air Built-in Coffee System
2
Installation Requirements
INSTALLATION REQUIREMENTS
Tools and Parts
T20
Torx
screwdriver
®†
®†
I
Drill
I
⁵⁄₆₄" (2 mm) drill bit
I
A
B
E
G
F
E. 4.5 x 16 mm
T20 screws (19)
F. 4.2 x 9.5 mm
T20 screws (4)
G. Leveling spacers (8)
Refer to installation instructions for cutout dimensions for any
I
appliances installed above or below the built-in coffee
system.
IMPORTANT: To avoid damage to your cabinets, check with
I
your builder or cabinet supplier to make sure that the
materials used will not discolor, delaminate or sustain other
damage. This coffee system has been designed in
accordance with the requirements of UL and CSA
International and complies with the maximum allowable
wood cabinet temperature of 194°F (90°C).
Product Dimensions
18"
(45.5 cm)
*From front of coffee system cavity to back of electrical box.
**From front corner to rear corner of coffee system cavity.