16
BRAKE SYSTEM
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
B01696-10
–
Remove screws
–
Press back the brake linings with a light lateral tilting of the brake caliper on the
brake disc. Carefully pull the brake caliper backwards from the brake disc..
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
B01697-10
–
Remove cotter pin
–
Remove pin
–
Take off retaining spring
–
Clean the brake caliper.
–
Position the new brake linings.
Info
Always change the full set of brake linings.
B01698-10
–
Position retaining spring
–
Mount bolt
–
Mount cotter pin
Info
To make it easier to mount the bolt, push the retaining spring down.
Make sure the retaining spring is seated correctly.
–
Position the brake caliper. Mount screws
–
Operate the hand brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point. Fix the hand brake lever in the acti-
vated position.
The brake caliper straightens.
–
Tighten screws
Guideline
Screw, front brake caliper
B01697-10
–
Remove the fixation of the hand brake lever.
–
Add brake fluid to level
Guideline
Level
A
tainer rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
B01699-10
Clean up overflowed or spilt brake fluid immediately with water.
.
1
with membrane
.
2
3
and spacers.
4
.
5
.
6
and remove the brake linings.
7
.
7
.
6
.
5
.
4
M8
.
A
(brake fluid level below con-
p. 202)
with the spacers but do not tighten yet.
4
25 Nm
Loctite
(18.4 lbf ft)
5 mm (0.2 in)
85
®
243™