KTM Freeride 250 R EU Repair Manual page 25

6 FORK, TRIPLE CLAMP
–
Grease the O-ring of tap rebound
Lubricant (T158) (
–
Mount and tighten the tap rebound.
Guideline
Tap rebound
–
Position spring
200718-10
–
Mount shim stack
–
Press the shim stack downward against the spring force.
Info
The shim stack must be pressed downward over the collar.
–
Mount piston
Info
The side with the largest inside diameter faces downward.
201464-10
–
Mount shim stack
Info
Align the triangular plate exactly with the piston opening.
–
Mount and tighten nut
Guideline
Tap rebound nut
201465-10 Info
Mount the nut with the collar facing downward.
–
Secure the nut by locking.
–
Slide screw sleeve
200696-11
–
Screw on water excluder
Info
The water excluder must be screwed on tightly against the stop. Do not use
a tool.
–
Slide piston rod
200721-10
–
Clamp the special tool in a bench vise.
Pin (T605) (
–
Hitch cartridge
200693-11
.
3
p. 204)
M9x1
.
4
with the smaller shims facing downward.
5
with the piston ring.
6
.
7
.
8
with the washer and spring seat onto the cartridge.
9
to the stop.
bk
into cartridge .
bl bm
p. 214)
by using the drilled holes.
bm
18 Nm Loctite
(13.3 lbf ft)
M6x0.5 5 Nm (3.7 lbf ft)
23
® 2701™