KTM Freeride 250 R EU Repair Manual page 105

18 30/ENGINE
–
Remove screws
–
Take off the throttle slide cover and pull the throttle slide out of the carburetor.
–
Hang the throttle slide to the side.
Info
Protect the vehicle and its attachments from damage by covering them.
–
Loosen hose clip
–
Pull the carburetor out of the intake flange toward the rear and remove it.
202711-10
–
Remove screws
–
Remove the engine sprocket cover.
202712-10
–
Remove screws
–
Remove cable binder
–
Take off the clutch slave cylinder and hang it to the side.
Info
Do not activate the clutch lever if the clutch slave cylinder has been
removed.
202713-10
–
Remove nut
–
Pull out the wheel spindle only far enough to allow the rear wheel to be pushed for-
ward.
–
Push the rear wheel forward as far as possible and take the chain off the rear
sprocket.
Info
Protect the vehicle and its attachments from damage by covering them.
The rear wheel must not be fully removed.
202715-10
–
Remove lock ring
–
Take off the engine sprocket.
202714-10
–
Remove screw
–
Remove fitting
–
Remove cable binders
–
Remove the brace.
–
Remove the spark plug.
202716-10
.
bt
.
ck
.
cl
.
cm
.
cn
. Remove the chain adjuster.
co
.
cp
on both sides.
cq
.
cr
.
cs
103