16
BRAKE SYSTEM
–
Stand the vehicle upright.
–
Remove screws
–
Remove cover with membrane
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
B01689-10
–
Take off cotter pin
–
Take off retaining spring
–
Clean the brake caliper.
B01690-10
–
Position the new brake linings.
Info
Always change the full set of brake linings.
B01691-01
–
Position retaining spring
–
Mount bolt
–
Mount cotter pin
Info
To make it easier to mount the bolt, push the retaining spring down.
Make sure the retaining spring is seated correctly.
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
B01690-10
–
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Mount the cover with membrane
–
Mount and tighten screws
Info
Clean up overflowed or spilt brake fluid immediately with water.
B01692-10
.
1
.
2
and remove bolt
3
and remove the brake linings.
5
.
5
.
4
.
3
.
A
p. 202)
.
2
.
1
.
4
90