Mld Snooping Querier Configuration Example - HP FlexFabric 5700 Series Configuration Manual

Verifying the configuration
# Display information about the static router ports in VLAN 100 on Switch A.
[SwitchA] display mld-snooping static-router-port vlan 100
VLAN 100:
Router slots (1 in total):
1
Router ports (1 in total):
XGE1/0/3
The output shows that Ten-GigabitEthernet 1/0/3 on Switch A has become a static router port.
# Display information about the static MLD snooping forwarding entries in VLAN 100 on Switch C.
[SwitchC] display mld-snooping static-group vlan 100
Total 1 entries).
VLAN 100: Total 1 entries).
(::, FF1E::101)
Host slots (0 in total):
Host ports (2 in total):
XGE1/0/3
XGE1/0/5
The output shows that Ten-GigabitEthernet 1/0/3 and Ten-GigabitEthernet 1/0/5 on Switch C have
become static member ports of the IPv6 multicast group FF1E::101.

MLD snooping querier configuration example

Network requirements
As shown in
The network is a Layer 2-only network.
•
Source 1 and Source 2 send multicast data to the multicast groups FF1E::101 and FF1E::102,
•
respectively.
• Host A and Host C are receivers of multicast group FF1E::101, and Host B and Host D are receivers
of multicast group FF1E::102.
All receiver hosts run MLDv1 and all switches run MLDv1 snooping. Switch A (which is close to the
•
multicast sources) acts as the MLD snooping querier.
To prevent the switches from flooding unknown IPv6 packets in the VLAN, enable dropping unknown
IPv6 multicast packets on all switches.
Figure 27:
82