Swaveform Subsystem; Introduction - HP 1652B Programming Reference Manual

SWAVeform Subsystem

Introduction

HP 1652B/1653B
Programming Reference
The commands in the State Waveform subsystem allow you to configure
the display so that you can view state data as waveforms on up to 24
channels identified by label name and bit number. The five commands are
analogous to their counterparts in the Tii Waveform subsystem.
However, in this subsystem the x-axis is restricted to representing only
samples (states), regardless of whether time tagging is on or off. As a
result, the only commands which can be used for scaling are DELay and
The way to manipulate the X and 0 markers on the Waveform display is
through the State Listing (SLISt) subsystem. Using the marker commands
from the SLISt subsystem will affect the markers on the Waveform display.
The commands in the SWAVeform subsystem are:
l
l
l
l
l
SWAVeform Subsystem
14-1