LOAD
Note d
Command Syntax:
where:
Examples:
HP 16528/1653B
Programming Reference
[:CONFig]
The LOAD command loads a file from the disk into the analyzer. The
[:CONfig] specifier is optional and has no effect on the command. The
logic analyzer.
Any previous setups and data in the instrument are replaced by the
contents of the configuration file.
:: = string of up to 10 alphanumeric characters representing a valid file name
O U T P U T XXX;":MMEMORY:LOAD:CONFIG ' F I L E - " '
O U T P U T XXX;":MMEMORY:LOAD ' F I L E - " '
OUTPUT XXX;":MMEM:LOAD:CONFIG
'FILE-A"'
LOAD
command
Subsystem