Table of Contents
Advertisement
DELay
command/query
DELay
The DELay command specifies the amount of time between the timing
trigger and the horizontal center of the the timing waveform display. The
allowable values for delay are -2500 s to + 2500 s. In glitch acquisition
mode, as delay becomes large in an absolute sense, the sample rate is
adjusted so that data will be acquired in the time window of interest. In
transitional acquisition mode, data may not fall in the time window since
the sample period is ftved at 10 11s and the amount of time covered in
memory is dependent on how frequent the input signal transitions occur.
The DELay query returns the current time offset (delay) value from the
trigger.
Command Syntax:
where:
:: = real number between -2500 s and + 2!500
Example:
OUTPUT XXX ; " :MACHINEl:TWAVEFORM:DELAY lOOE-6"
Query Syntax:
<time-value > < NL >
Returned Format:
20 OUTPUT XXX;":MACHINEl:TWAVEFORM:DELAY?"
30 ENTER XXX; Ol$
4 0 P R I N T 01s
HP 16528/1663B
Advertisement
Table of Contents
