Table of Contents
Advertisement
MEASure Subsystem
Introduction
HP 16528/1663B
The instructions in the MEASure subsystem are used to make automatic
parametric measurements on displayed waveforms. The instructions are:
ALL
l
l
l
l
l
l
l
l
l
l
l
VMIN
l
VPP
l
Before using any of the MEASure subsystem queries, be sure that you
have used to SOURce command to specify which channel is to be used.
All subsequent measurements will be made from that channel's waveform.
If a waveform characteristic cannot be measured, the instrument responds
with 9.9E + 37.
MEASure Subsystem
27-1
Advertisement
Table of Contents
