3Com WX1200 Reference Manual page 276

276 C 7: C
HAPTER ONFIGURING
W P
IRELESS ARAMETERS
c Click the plus sign next to Wireless.
d Select Access Points.
e In the Task List panel, select Distributed AP.
2 In the Name box, type a name (1 to 16 alphanumeric characters, with no
spaces or tabs).
3 In the DAP Number box, specify the connection number for the WX
switch's connection to this Distributed MAP. The range of valid
connection numbers depends on the WX switch model:
For a WX4400, you can specify a number from 1 to 300.
For a WX1200, you can specify a number from 1 to 30.
For a WXR100, you can specify a number from 1 to 8.
4 In the Serial Number box, type the serial number of the MAP.
5 In the Fingerprint box, type the 16-digit hexadecimal number of the
MAP's encryption fingerprint. Use either of the following formats:
11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ff:00
1122:3344:5566:7788:99aa:bbcc:ddee:ff00
A MAP's fingerprint is the hash value of the MAP's public encryption key.
The fingerprint is displayed on a label on the back of the MAP, and is
labeled RSA key. If the MAP is already installed and operating, use the CLI
command display dap status command to display the fingerprint.
The fingerprint is used for secure communication between the WX switch
and the MAP, and applies only to Distributed MAPs.
6 Click Next.
7 Select the MAP model from the MAP Model list.
8 To select the radio type for a single-radio model, click the MAP Radio
Type box and select the radio type from the list:
11a—802.11a
11b—802.11b only
11g—802.11b/g
9 Click Next.
10 Configure the radios:
a To enable the radio, select Enabled.