Upgrading The Ds Storage Manager On The Windows Operating System Using Unattended (Silent) Mode - IBM DS8000 User Manual

18. Complete the post installation tasks. If, when exiting the installation wizard,
19. End the LaunchPad program by clicking Exit on the LaunchPad window.
Upgrading the DS Storage Manager on the Windows operating system
using unattended (silent) mode
Complete this task to upgrade the IBM System Storage DS Storage Manager in
your Windows environment using the unattended (silent) mode.
It is recommended that you upgrade the level of code before upgrading the DS
Storage Manager.
Notes:
Using the unattended (silent) mode upgrade option allows you to run the upgrade
program unattended. Use this method of upgrade to issue a command from a
command prompt window, in the root directory of the IBM System Storage DS
Storage Manager CD.
Perform the following steps to upgrade the IBM System Storage DS Storage
Manager in your Windows environment using the unattended (silent) mode:
1. Log on to your Windows system as an administrator.
2. Insert the IBM System Storage DS Storage Manager upgrade CD into the
3. Type the following command at the command prompt: setup.exe -silent. Press
4. Check the install log file for any possible error messages. This file is located in
5. Start the IBM System Storage DS Storage Manager if no errors are evident.
6. Perform the postinstallation tasks when the DS Storage Manager has been
56
DS8000 User's Guide
v If the error is due to a system problem, correct it and reinstall the DS8000
Storage manager using either the interactive or unattended (silent) mode of
installation.
v If the error is due to a wrong installation parameter value, restart the
installation using the steps that are described in this procedure or the steps
that are described in the unattended (silent) mode installation process.
Navigate to the Server Parameters window and insert the correct values.
Finish the installation process.
the postinstallation.txt file does not automatically open, manually open it from
the LaunchPad window, and follow the instructions to complete the post
installation tasks.
1. The name of the user who logs on and performs the installation must
not contain any non-ASCII or special characters. It could cause the
installation to fail.
2. The DS Storage Manager is not supported on any Windows 64-bit
operating system.
CD-ROM drive. If the interactive mode starts, click the Exit selection on the
LaunchPad window to end the program.
the Enter key to start the upgrade process in unattended (silent) mode.
the xxx\logs\install.log directory, where xxx is the destination directory where
the DS Storage Manager is installed.
installed successfully. You can access the instructions for the post installation
tasks from the postinstallation.txt file, in the doc directory on the product CD.