IBM DS8000 User Manual page 70

16. Click Finish to exit the installation process. When the installation process
17. Start the DS Storage Manager. See "Starting the DS Storage Manager on a
18. Complete the postinstallation tasks. If, when exiting the installation wizard,
19. Exit the LaunchPad program by clicking Exit on the LaunchPad window.
42
DS8000 User's Guide
Note: You can click Cancel (not recommended) during the components
installation process. The installation process stops immediately when
the Cancel button is clicked. A window with a confirmation
message is displayed. For a new installation, when you confirm that
you want to stop the process, all of the component files that have
been copied up to the point that the Cancel button was clicked are
uninstalled and the installation process is cancelled.
When this part of the installation is completed, if no system restart is
required, the system starts both servers: first the DS Network Interface Server
and then the DS Storage Manager Server. Wait for the servers to be started
before going to the next step. When the servers have been started, the Installer
Finish window is displayed with the result of the installation process
(successful or unsuccessful).
If a system restart is required, the Installer Finish window is displayed, which
asks you to restart the system. Click Next on the Finish window. The Installer
Reboot window is displayed. Choose the default selection Yes, restart my
computer on the Reboot window, and then click Finish. Both servers, first the
DS Network Interface Server and then the DS Storage Manager Server, start
automatically after the restart.
exits, a file (postinstallation.txt) is displayed, containing the post installation
tasks. Use these instructions to complete the setup tasks.
Note: If the Finish window indicates that the installation fails, you must exit
the installation process and check the installation log for error
messages. The installation log is located in xxx\logs\install.log, where
xxx is the destination directory where the IBM System Storage DS
Storage Manager is installed (for example, c:\Program
Files\IBM\DS8000 Storage Manager) .
Errors fall into two categories: system problems or incorrect values that
are designated during the installation process. Use the following
guidelines to correct these errors.
v If the error is due to a system problem, correct it and reinstall the DS
Storage Manager using either the interactive or unattended (silent)
mode of installation.
v If the error is due to a wrong installation parameter value, restart the
installation using the steps that are described in this procedure or the
steps that are described in the unattended (silent) mode of
installation. Navigate to the Server Parameters window and insert the
correct values. Then finish the installation process.
Windows operating system" on page 81.
the postinstallation.txt file does not automatically open, manually open it from
the LaunchPad window, and follow the instructions to complete the post
installation tasks.