Table of Contents
Advertisement
Table 5. Remote mirror and copy return codes (continued)
Return
code
Return code explanation
X'07'
There is a secondary LSS subsystem identifier (SSID) mismatch, or failure of
the I/O that collects the secondary information for validation.
X'08'
The ESCON link is offline. This is caused by the lack of light detection coming
from a host, peer, or switch.
X'09'
The establish failed. It is retried until the command succeeds or a remove
paths command is run for the path.
Note: The attempt-to-establish state persists until the establish path operation
succeeds or the remove remote mirror and copy paths command is run for the
path.
X'0A'
The primary storage unit port or link cannot be converted to channel mode if a
logical path is already established on the port or link. The establish paths
operation is not retried within the storage unit.
X'10'
Configuration error. The source of the error is one of the following:
1. The specification of the secondary adapter ID does not match the installed
ESCON adapter in the primary storage unit.
2. For ESCON paths, the secondary storage unit destination address is zero
and the ESCON director (switch) was found in the path.
3. For ESCON paths, the secondary storage unit destination address is not
zero and an ESCON director does not exist in the path. The path is a direct
connection.
X'14'
The fibre-channel path link is down.
X'15'
The maximum number of fibre-channel path retry operations has been
exceeded.
X'16'
The fibre-channel path secondary adapter is not remote mirror and copy
capable. This could be caused by one of the following conditions:
v The secondary adapter is not configured properly or does not have the
current firmware installed.
v The secondary adapter is already a target of 32 different logical subsystems
(LSSs).
X'17'
The secondary adapter fibre-channel path is not available.
X'18'
The maximum number of fibre-channel path primary login attempts has been
exceeded.
X'19'
The maximum number of fibre-channel path secondary login attempts has
been exceeded.
X'1A'
The primary fibre-channel adapter is not configured properly or does not have
the correct firmware level installed.
X'1B'
The fibre-channel path established but degraded due to a high failure rate.
X'1C'
The fibre-channel path was removed due to a high failure rate.
Specific trap 101 - Remote mirror and copy links are inoperable
This trap displays when an established remote mirror and copy
path between a primary and secondary logical subsystem pair
becomes inoperable, and there are no other operational paths
between the two logical subsystems. The following information is
provided for specific trap 101:
ssEventDescr=yyyy/MM/dd hh:mm:ss tzn
-error_description-
UNIT: Mnf Type-Mod SerialNm LS
PRI: xxx tttt-ooo pp-zzzzz ll
Appendix. Troubleshooting and analyzing problems
161
Hide quick links:
Advertisement
Table of Contents
