Management Settings - D-Link xStack DES-3200 Series Reference Manual

The fields that can be configured or displayed are described below:
Parameter
Interface Name
IPv6 State
Interface Admin State
IPv6 Network Address
NS Retransmit Time (0-
4294967295)
Automatic Link Local
Address
Click the Apply button to accept the changes made for each individual section.
Click the <<Back button to discard the changes made and return to the previous page.
Click the View All IPv6 Address
Click the View All IPv6 Address
Click the <<Back button to return to the previous page.

Management Settings

Users can stop the scrolling of multiple pages beyond the limits of the console when using the Command Line
Interface.
This window is also used to enable the DHCP auto configuration feature on the Switch. When enabled, the Switch
is instructed to receive a configuration file from a TFTP server, which will set the Switch to become a DHCP client
automatically on boot-up. To employ this method, the DHCP server must be set up to deliver the TFTP server IP
address and configuration file name information in the DHCP reply packet. The TFTP server must be up and
running and hold the necessary configuration file stored in its base directory when the request is received from the
Switch. For more information about loading a configuration file for use by a client, see the DHCP server and/or
TFTP server software instructions. The user may also consult the Upload Log File window description located in
the Tools section of this manual.
If the Switch is unable to complete the DHCP auto configuration, the previously saved configuration file present in
the Switch's memory will be used.
Users can also configure Password Encryption on the Switch.
To view the following window, click Management > Management Settings, as show below:
xStack® DES-3200 Series Layer 2 Managed Fast Ethernet Switch
Description
Display the IPv6 interface name.
Use the drop-down menu to enable or disable IPv6 State.
Use the drop-down menu to enable or disable the Interface Admin State.
Here the user can enter the IPv6 global or local link address.
Enter the Neighbor solicitation's retransmit timer in millisecond here. It has the same
value as the RA retransmit time in the config ipv6 nd ra command. If this field is
configured, it will duplicate the entry into the RA field.
Here the user can select to enable or disable the Automatic Link Local Address.
link to view all the current IPv6 address.
link to see the following window.
Figure 3-11 IPv6 Interface Settings window
29