Layer 2 Protocol Tunneling Settings - D-Link xStack DES-3200 Series Reference Manual

configured rule. On egress at this port, the SP-VLAN tag will be recovered to C-VLAN tag or be striped. The priority
will be the priority in the SP-VLAN tag if the inner priority flag is disabled for the receipt port.
To view the following window, click L2 Features > QinQ > VLAN Translation Settings, as show below:
The fields that can be configured are described below:
Parameter
From Port / To Port
CVID (1, 5-7)
Action
SVID (1-4094)
Priority
Click the Apply button to accept the changes made for each individual section.
Click the Delete All button to remove all the entries listed.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove a specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

Layer 2 Protocol Tunneling Settings

This window is used to configure Layer 2 protocol tunneling settings.
To view the following window, click L2 Features > Layer 2 Protocol tunneling Settings, as show below:
The fields that can be configured are described below:
Parameter
Layer 2 Protocol
Tunneling State
xStack® DES-3200 Series Layer 2 Managed Fast Ethernet Switch
Figure 4-20 VLAN Translation Settings Window
Description
Use the drop-down menus to select a range of ports to use in the configuration.
Enter the C-VLAN ID to match.
The action indicates to add an S-tag before a C-tag or to replace the original C-tag by an
S-tag.
Enter the SP-VLAN ID.
Use the drop-down menu to select the priority of the s-tag.
Figure 4-21 Layer 2 Protocol Tunneling Settings window
Description
Click to enable or disable the Layer 2 protocol tunneling state.
67