System Log Server Settings; System Log - D-Link xStack DES-3200 Series Reference Manual

Click the Apply button to accept the changes made for each individual section.

System Log Server Settings

The Switch can send System log messages to up to four designated servers using the System Log Server.
To view the following window, click System Configuration > System Log Configuration > System Log Server
Settings, as show below:
The fields that can be configured are described below:
Parameter
Server ID
Severity
Server IPv4 Address
Facility
UDP Port (514 or
6000-65535)
Status
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Click the Delete All button to remove all servers configured.

System Log

Users can view and delete the local history log as compiled by the Switch's management agent.
To view the following window, click System Configuration > System Log Configuration > System Log, as show
below:
xStack® DES-3200 Series Layer 2 Managed Fast Ethernet Switch
Figure 2-12 System Log Server Settings
Description
Syslog server settings index (1 to 4).
Use the drop-down menu to select the higher level of messages that will be sent. All
messages which level is higher than selecting level will be sent. The options are
Emergency, Alert, Critical, Error, Warning, Notice, Informational and Debug.
The IPv4 address of the Syslog server.
Use the drop-down menu to select Local 0, Local 1, Local 2, Local 3, Local 4, Local 5,
Local 6, or Local 7.
Type the UDP port number used for sending Syslog messages. The default is 514.
Choose Enabled or Disabled to activate or deactivate.
16