Interface Settings - D-Link xStack DES-3200 Series Reference Manual

Click the Apply button to accept the changes made.

Interface Settings

Users can display the Switch's current IP interface settings.
To view the following window, click Management > IP Interface > Interface Settings, as show below:
The fields that can be configured are described below:
Parameter
Interface Name
Click the Find button to locate a specific entry based on the information entered.
Click the Add button to add a new entry based on the information entered.
Click the Delete All button to remove all the entries listed.
Click the IPv4 Edit button to edit the IPv4 settings for the specific entry.
Click the IPv6 Edit button to edit the IPv6 settings for the specific entry.
Click the Delete button to remove the specific entry.
NOTE: To create IPv6 interfaces, the user has to create an IPv4 interface then edit it to IPv6.
Click the Add button to see the following window.
The fields that can be configured are described below:
Parameter
Interface Name
IPv4 Address
Subnet Mask
VLAN Name
xStack® DES-3200 Series Layer 2 Managed Fast Ethernet Switch
as an IP gateway. If your network is not part of an intranet, or you do not want the
Switch to be accessible outside your local network, you can leave this field
unchanged.
Figure 3-7 Interface Settings window
Description
Enter the name of the IP interface to search for.
Figure 3-8 IPv4 Interface Settings window
Description
Enter the name of the IP interface being created.
Enter the IPv4 address used.
Enter the IPv4 subnet mask used.
Enter the VLAN Name used.
27