Advertisement
Quick Links
EBA2580 eZ.HD Series
5MP, IP66 IR Dome Camera
User's Manual
Copyright © EverFocus Electronics Corp.
Release Date: September, 2019
All the images including product pictures or screen shots in this document are for example
only. The images may vary depending on the product and software version. Information
contained in this document is subject to change without notice.
EverFocus Taiwan:
2F., No.12, Ln. 270, Sec. 3, Beishen Rd., Shenkeng Dist., New Taipei City 222, Taiwan
TEL: +886 2 2662 2338 FAX: +886 2 2662 3632 www.everfocus.com.tw
Advertisement
Related Manuals for EverFocus EBA2580 eZ.HD Series
Summary of Contents for EverFocus EBA2580 eZ.HD Series
- Page 1 The images may vary depending on the product and software version. Information contained in this document is subject to change without notice. EverFocus Taiwan: 2F., No.12, Ln. 270, Sec. 3, Beishen Rd., Shenkeng Dist., New Taipei City 222, Taiwan TEL: +886 2 2662 2338 FAX: +886 2 2662 3632 www.everfocus.com.tw...
- Page 2 1. Introduction EverFocus eZ.HD series cameras – EBA2580 deliver 5MP image quality. The model is equipped with Sony STARVIS CMOS sensor and provides 2.8-12mm lens with ICR. Featured with True Wide Dynamic Range (T-WDR), the camera can provide clear images even under backlight circumstances where intensity of illumination can vary excessively.
-
Page 3: Installation
1.4 Optional Accessory BA-E320 Color / Material: White / Metal Size (Φ x H): 138 x 54mm / 5.43” x 2.13” Weight: 700g / 1.5lb BA-EB45 Color / Material: White / Metal Size (W x D x H): 245 x 160 x 163mm / 9.65”x 6.3”x 6.42” Weight: 2.1kg / 4.63lb 1.5 Cable Description 12VDC... - Page 4 a. If you want to wire the cables from the Side Cut on the Camera Base: Attach the Camera Body to the Camera Base and run the cables through the Camera Base, and then place the cable under the Side Cut. Finally, screw the Camera Base to the surface with the supplied 4 Screws.
- Page 5 5. Connect the Power Cable to a 12VDC power source. Connect the Video Output Cable to a monitor or DVR. 6. For the first time installation, check whether the camera is properly focused. If not, you can optionally adjust camera zoom and focus by adjusting the Zoom Screw or Focus Screw using a slotted screwdriver.
- Page 6 3. Configuration in the OSD Menu No Main Sub Menu Sub Menu / Function Level 0-10 YEL, CYN, GRN, MAG, RED, BLU, BLK, Edge Det Color Brightness 0-20 Auto Mode Normal / Deblur 1/30, 1/60, 1/120, 1/250, 1/500, 1/1000, 1/2000, Shutter Manual Speed...
- Page 7 Anti-Sat. 0-20 D>N Thres 0-20 N>D Thres 0-20 Delay High, Middle, Low IR LED Adaptive, Off Anti-Sat. 0-20 Extern SW High, Low Extern D>N Thres 0-20 N>D Thres 0-20 Delay High, Middle, Low Auto Autoext Preset Color C-Temp 3000K, 5000K, 8000K Manual R-Gain 0-20...
- Page 8 CB Level 0-20 CR Level 0-20 Trans Window Use Window Zone On, Off Det H-POS 0-80 Det Window Det V-POS 0-60 Det H-Size 0-80 Motion Det V-Size 0-60 Sensitivity 0-10 Motion OSD On, Off Text Alarm On, Off Signal Out On, Off 4K/15fps, 4MP/30fps, 1080p/30fps, Frame Rate...