Configuring Ipv6 Parameters - Alcatel-Lucent 7450 Configuration Manual

Common Configuration Tasks

Configuring IPv6 Parameters

The following displays the interface configuration showing the IPv6 default configuration
when IPv6 is enabled on the interface.
A:ALA-49>config>router>if>ipv6# info detail
----------------------------------------------
----------------------------------------------
A:ALA-49>config>router>if>ipv6# exit all
The following displays an IPv6 configuration example.
A:ALA-49>config>router>if# info
----------------------------------------------
----------------------------------------------
A:ALA-49>config>router>if#
An Example of a IPv6 Over IPv4 Tunnel Configuration
The IPv6 address is the next-hop as it is received through BGP. The IPv4 address is the
system address of the tunnel's endpoint.
This configuration displays an example to configure a policy to export IPv6 routes into BGP.
CLI Syntax:
The following displays the configuration showing the policy output.
78
port 1/3/37
ipv6
packet-too-big 100 10
param-problem 100 10
redirects 100 10
time-exceeded 100 10
unreachables 100 10
exit
address 10.11.10.1/24
port 1/3/37
ipv6
address 10::1/24
exit
config>router
bgp
export policy-name [policy-name...(upto 5 max)]
router-id ip-address
group name
family [ipv4] [vpn-ipv4] [ipv6] [mcast-ipv4]
type {internal | external}
neighbor ip-address
local-as as-number [private]
peer-as as-number
Router Configuration Guide