Configuring Proxy Arp - Alcatel-Lucent 7450 Configuration Manual

A:ALA-49>configure>router# info
----------------------------------------------
...
----------------------------------------------
A:ALA-49>configure>router#

Configuring Proxy ARP

To configure proxy ARP, you can configure:
CLI Syntax:
Use the following CLI syntax to configure the policy statement specified in the proxy-arp-
policy policy-statement command.
Router Configuration Guide
policy-options
policy-statement "ospf3"
description "Plcy Stmnt For 'From ospf3 To bgp'"
entry 10
description "Entry From Protocol ospf3 To bgp"
from
protocol ospf3
exit
to
protocol bgp
exit
action accept
exit
exit
exit
exit
• A prefix list in the config>router>policy-options>prefix-list context.
• A route policy statement in the config>router>policy-options>policy-statement
context and apply the specified prefix list.
→ In the policy statement entry>to context, specify the host source address(es) for
which ARP requests can or cannot be forwarded to non-local networks,
depending on the specified action.
→ In the policy statement entry>from context, specify network prefixes that ARP
requests will or will not be forwarded to depending on the action if a match is
found. For more information about route policies, refer to the Unicast Routing
Protocols Guide.
• Apply the policy statement to the proxy-arp configuration in the
config>router>interface context.
config>router# policy-options
begin
commit
prefix-list name
prefix ip-prefix/mask [exact | longer | through
length | prefix-length-range length1-length2]
IP Router Configuration
79