Priority Policy Lag Events Commands - Alcatel-Lucent 7450 Configuration Manual

Ethernet service switch/service router/extensible routing syste

Hide thumbs Also See for 7450:

Table of Contents

VRRP Configuration Command Reference

Priority Policy LAG Events Commands

lag-port-down

[no] lag-port-down lag-id

config>vrrp>policy>priority-event

This command creates the context to configure Link Aggregation Group (LAG) priority control events

that monitor the operational state of the links in the LAG.

The lag-port-down command configures a priority control event. The event monitors the operational

state of each port in the specified LAG. When one or more of the ports enter the operational down state,

the event is considered to be set. When all the ports enter the operational up state, the event is

considered to be clear. As ports enter the operational up state, any previous set threshold that represents

more down ports is considered cleared, while the event is considered to be set.

The POS channel on the port monitored by the VRRP priority

control event. The port-id.channel-id can only be monitored by a

single event in this policy. The channel can be monitored by

multiple VRRP priority control policies. A port and a specific

channel on the port are considered to be separate entities. A port

and a channel on the port can be monitored by separate events in

the same policy.

If the port is provisioned, but the channel does not exist or the port

has not been populated, the appropriate event operational state is

Set – non-populated.

If the port is not provisioned, the event operational state is Set –

non-provisioned.

If the POS interface is configured as a clear-channel, the channel-

id is 1 and the channel bandwidth is the full bandwidth of the port.

pxc-id.sub-port

ccag-id. path-id[cc-type]

Router Configuration Guide

.sap-net, .net-sap