Alcatel-Lucent 7450 Configuration Manual page 532

Filter Configuration Command Reference
The no form of the command sets the scope of the policy to the default of template.
Default
template
Parameters
exclusive — When the scope of a policy is defined as exclusive, the policy can only be applied to
template — When the scope of a policy is defined as template, the policy can be applied to
embedded — When the scope of a policy is defined as embedded, the policy cannot be applied
system — When the scope of a policy is defined as system, the policy defines system-wide filter
shared-radius-filter-wmark
Syntax shared-radius-filter-wmark low low-watermark high high-watermark
no shared-radius-filter-wmark
Context config>filter>ip-filter
config>filter>ipv6-filter
Description This command configures the low and high watermark for the number of RADIUS shared filters
reporting
Default
no shared-radius-filter-wmark
Parameters low low-watermark — Specifies the utilization of the filter ranges for filter entry insertion, at
high high-watermark — Specifies the utilization of the filter ranges for filter entry insertion, at
sub-insert-credit-control
Syntax sub-insert-credit-control start-entry entry-id count count
no sub-insert-credit-control
Context config>filter>ip-filter
config>filter>ipv6-filter
532
a single entity. Attempting to assign the policy to a second entity will result in an error
message.
multiple entities.
directly. The policy defines embedded filter rules, which are embedded by other exclusive/
template/system filter policies. The embedded scope is supported for IPv4 and IPv6 filter
policies only.
rules. To apply system policy rules, activate system filter and chain exclusive/template ACL
filter policy to the system filter. The system scope is supported for IPv4 and IPv6 filter
policies only.
which a table full alarm will be raised by the agent.
Values
0 to 8000
which a table full alarm will be cleared by the agent.
Values 1 to 8000
Router Configuration Guide