Common Configuration Tasks - Alcatel-Lucent 7450 Configuration Manual

Common Configuration Tasks

echo "IP Configuration "
#------------------------------------------
#------------------------------------------
A:SR4>config>router#
Common Configuration Tasks
This section provides a brief overview of the tasks that must be performed to configure VRRP
and provides the CLI commands.
VRRP parameters are defined under a service interface or a router interface context. An IP
address must be assigned to each IP interface. Only one IP address can be associated with an
IP interface but several secondary IP addresses also be associated.
Owner and non-owner configurations must include the following parameters:
Other owner and non-owner configurations include the following optional commands:
In addition to the common parameters, the following non-owner commands can be
configured:
396
interface "system"
address 10.10.0.4/32
exit
interface "test1"
address 10.10.14.1/24
secondary 10.10.16.1/24
secondary 10.10.17.1/24
secondary 10.10.18.1/24
exit
interface "test2"
address 10.10.10.23/24
vrrp 1 owner
backup 10.10.10.23
authentication-key "testabc"
exit
exit
• All participating routers in a VRRP instance must be configured with the same vrid.
• All participating non-owner routers can specify up to 16 backup IP addresses (IP
addresses the master is representing). The owner configuration must include at least
one backup IP address.
• For IPv6, all participating routers must be configured with the same link-local
backup address (the one configured for the owner instance.)
• authentication-key
• MAC
• message-interval
Router Configuration Guide