Tunnel Ingress Node - Alcatel-Lucent 7450 Configuration Manual

Common Configuration Tasks

Tunnel Ingress Node

This configuration shows how the interface through which the IPv6 over IPv4 traffic leaves
the node. This must be configured on a network interface.
CLI Syntax:
The following displays configuration output showing interface configuration.
A:ALA-49>configure>router# info
----------------------------------------------
...
...
----------------------------------------------
A:ALA-49>configure>router#
Both the IPv4 and IPv6 system addresses must to configured.
CLI Syntax:
70
→
Configuring an IPv4 BGP Peer
→
An Example of a IPv6 Over IPv4 Tunnel Configuration
• Tunnel Egress Node
→
Learning the Tunnel Endpoint IPv4 System Address
→
Configuring an IPv4 BGP Peer
→
An Example of a IPv6 Over IPv4 Tunnel Configuration
config>router
static-route-entry::C8C8:C802/128
interface "ip-1.1.1.1"
address 1.1.1.1/30
port 1/1/1
exit
config>router
interface ip-int-name
indirect 200.200.200.2
interface ip-int-name
address {ip-address/mask | ip-address
netmask} [broadcast {all-ones |
host-ones}]
port port-name
address {ip-address/mask | ip-address netmask}
[broadcast {all-ones | host-ones}]
ipv6
address ipv6-address/prefix-length [eui-
64]
Router Configuration Guide