Channel Control "Punch Through - Universal Remote Control URC-A6 Owner's Manual

Channel Control "Punch Through"

This "Punch Through" enables you to program
the URC-A6 so that either the Cable or TV
Channel Controls (CHANNEL UP, DOWN,
LAST, CHANNEL NUMBERS 0-9, +10 and
ENTER) will also operate in other component
modes on the remote control.
STEP 1: Press and hold the component button
you want to add channel control to, such as
DVD or DVR, and the SELECT [SEL] button at
the same time for two seconds until the
Component LED light turns on.
IMPORTANT: You have 30 seconds to
perform the next step while you are in
programming mode. If you do not press a
button within 30 seconds, the component LED
light will turn off. The remote will exit the
programming mode and you will have to start
over.
STEP 2: Press the CHANNEL UP button. The
component LED light will blink once.
COMPONENT
BUTTONS
SELECT
CHANNEL
UP
STEP 3: Press either the TV or CBL button that
you want to use as the source of channel con-
trol. The component LED will blink three times
to confirm it is saved.
Page 21