Channel Control "Punch Through - Universal Remote Control URC-SR3 Owner's Manual

Channel Control "Punch Through"

This "Punch Through" enables you to program the
URC-SR3 so that either the Cable or TV Channel
Controls (CH+, CH-, LAST, CHANNEL NUMBERS
0~9, -/--, and ENT) will also operate in other
component modes on the remote control.
STEP 1: Press and hold the component button you
want to add channel control to, such as DVD, and
the SELECT [SEL] button at the same time for two
seconds until the Component LED light turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2: Press the CH ANNEL UP button. The
component LED light will blink once.
COMPONENT
BUTTONS
SELECT
CH
STEP 3: Press either the TV or CBL/SAT button
that you want to use as the source of channel con-
trol. The component LED will blink two times to con-
firm it is saved.
Page 21