Other Prot - EverFocus EPN5230 User Manual

EPN5230 / EPN5210
Password: Input the user's login password if the SMTP server requires authentication.
Email (from): Input the sender's e-mail address, so that the receiver can recognize the sender when an
Event message is received.
Email (to): Input the e-mail address (currently you can only specify one address) for receiving an e-mail
message when an Event is enabled and triggered.
Click the Save button on the bottom-right to save the settings.
【FTP Setting】
The settings relating to the FTP server used to transmit the recordings, snapshots and alarm files can
be configured here. Note that to enable uploading recordings to the FTP server function, you have to
check the FTP Upload box on Alarm > IO Alarm (see 7.4.2 IO Alarm) and Alarm > Motion > Parameter
Config pages (see 7.4.3.2 Parameter Config).
FTP Port: Enter the port number for the FTP server.
Address: Enter the IP address or the host name of the FTP server.
User Name: Set FTP User's name.
Password: Set FTP password.
Path: Assign the FTP path.
Click the Save button on the bottom-right to save the settings.

7.3.4. Other PROT

You can configure other protocol using this page.
【Other PROT】
Check the Enable box to enable the other protocol function. Select a protocol from the Protocol
Option drop-down list and fill in the required information in the columns below. Click the Save button
on the bottom-right to save the settings.
50