Servo - FUTABA T8J-2.4G Instruction Manual

SERVO display and cycle submenu:
GOAL of EXAMPLE:
6 from VR
SWITCH C.
Cycle the channel 6 servo.
Where next?
The servo submenu includes two features:
Real-time bar-graph display to demonstrate exactly what commands the
transmitter is sending to the servos. (This can be particularly handy in setting
up models with complicated mixing functions, because the results of each
Servo cycle function
Adjustability:
servos to be cycled.
STEPS:
C o m p l e t e d e s i r e d p r o g r a m m i n g
function. (Ex: in AUX-CH , move ch. 6 to
SWITCH C)
Open the SERVO function.
Move each control to see the operation.
(Ex: SWITCH C in all positions)
Prepare servos to be cycled.
Open the servo cycle function.
Set up cycle mode. (Ex: JMP mode)
Choose channels to be cycled. (Ex: ch. 6)
Cycle the channel 6 servo.
End cycling and close.
Set up dual/triple rates and exponential ( D/R , EXP ): see p. 39.
Set up desired programmable mixes: see p. 65.
Set up dual aileron servos: see p. 52.
Set up dual elevator servos: see p. 54.
INPUTS:
See AUX-CH for details. (p. 43.)
for 1 second.
to SERVO .
C to center position.
Note change in position of ch. 6 servo.
Plug in servos. POWER ON.
to GRAF> .
to TYPE .
to CH6 .
to TEST .
47
to JMP .
to ACT .