FUTABA T8J-2.4G Instruction Manual page 75

SWASH AFR (not in SWH1 ):
everything installed per factory instructions, set the model to HELI ( HR3
choices left—the whole function needs to be reversed, or the servo(s) not shared with aileron need to be reversed.
direction in which the collective operates (reverse the whole function). In our example, HR3 is 180 degrees off from the
collective pitch rate, however, from +50% to -50% , will reverse the collective pitch without affecting the aileron action.
HR3 Swash Type
AILERON STICK.
ELEVATOR STICK.
RUDDER STICK.
THROTTLE STICK.
GOAL of EXAMPLE:
Adjust the travel of the collective pitch
from +50% to -23% , reversing the travel
of all 3 servos and decreasing their
travel in collective pitch only, on an
HR3 SWASH TYPE .
Where next?
Swashplate function rate settings ( SWASH AFR ) reduce/increase/reverse the rate
(travel) of the aileron, elevator (except H-2 ) and collective pitch functions,
adjusting or reversing the motion of all servos involved in that function, only
when using that function. Since these types utilize multiple servos together to
properly correct the travel of any one control. Since H-1 uses one servo for each
CHECKING FOR PROPER MOTION ON AN HR3 SWASHPLATE
PROPER MOTION
Swashplate tilts right.
moves up.
The leading edges of tail
blades rotate left.
Entire Swashplate lifts.
STEPS:
Open SWASH AFR function.
Adjust PIT travel to -23% .
Close the menu.
Set up the normal condition: ( THR-CURV/NOR, PIT-CURV/NOR, REVO./NORM ):
see p. 78.
Set up D/R , EXP : see p. 39.
H-1 .
®
WRONG MOTION
Swashplate tilts left.
up.
down.
S w a s h p l a t e m o v e s t h e
opposite.
Entire swashplate moves up.
Blades rotated right.
Swashplate lowers.
INPUTS:
END POINT : see p. 36.
75
REVERSE or END POINT would not
HOW TO FIX
Reverse AIL setting in SWASH
to -50% .
REVERSE .
REVERSE .
Reverse ELE setting in SWASH .
(ex: +50 to -50 )
REVERSE .
REVERSE the rudder servo.
Reverse PIT setting in SWASH .
for 1 second.
to SWASH AFR .
to PIT . to -23% .