FUTABA T8J-2.4G Instruction Manual page 79

GOAL of EXAMPLE:
Set up Normal Flight Condition
Throttle/Collective Pitch Curves and
Revo.
Base point: Adjust base point of throttle
curve until engine idles reliably on the
ground. Adjust base point of collective
blade pitch. Apply throttle until the
base point of REVO . until model does not
rotate its nose at all.
Adjust collective pitch
curve to +5 degrees. Ease heli into a
hover. Land/shut engine off. Adjust
throttle curves and rudder trim. Repeat
until model hovers smoothly at half
throttle. Rapidly apply throttle from 1/4
REVO . until the nose
does not change heading.
Adjust collective pitch
throttle up rapidly. If engine bogs,
increase the throttle curve. If engine
curve at points 4 or 5. Apply full throttle
hover. Adjust REVO . until the nose does
not change heading.
Where next?
THROTTLE CUT:
The THROTTLE-CUT
STEPS:
Open the THR-CURV/NOR function.
Open the PIT-CURV/NOR function.
Open the REVO. /NORM function.
Adjust the high point. (Ex: 4% .)
Adjust THR-CURV/NOR .
Adjust PIT-CURV/NOR .
Adjust REVO. /NORM .
Adjust THR-CURV/NOR .
Adjust PIT-CURV/NOR .
Adjust REVO. /NORM .
GYRO function: see p. 87.
Adjust HOV-THR and HOV-PIT if needed: see p. 85.
GOVERNOR function: see p. 89.
D/R , EXP : see p. 39.
THROTTLE-CUT
idle). You must move the THROTTLE STICK
the THROTTLE-CUT function can be reset, to avoid sudden engine acceleration.
INPUTS:
for 1 second.
5% .)
to THR-CURV/NOR .
to POINT-1 .
to PIT-CURV/NOR .
8% .)
to POINT-1 .
to REVO. /NORM .
to MIX .
to HIGH .
Repeat above as needed.
Repeat above as needed.
Repeat above as needed.
Repeat above as needed.
Repeat above as needed.
Repeat above as needed.
ACRO p. 38.
79
to 5% .
to 8% .
to ON .
to 4% .