FUTABA T8J-2.4G Instruction Manual page 31

Receiver modulation select ( RX ): sets the type of modulation transmitted.
The modulation of your receiver will determine whether you utilize SFHSS or FHSS setting in RX during transmission.
SFHSS / FHSS
NOTE: When you change models in MODEL SELECT , if the new model is set to the other modulation type,
to remind you until you do so. See p. 27, MODEL SELECT , for details.
GOAL of EXAMPLE:
Change model 1 from SFHSS to FHSS .
Where next?
F/S ) settings as you intended (see p. 48).
SFHSS mode/ FHSS mode)
Adjustability:
SFHSS
number of channels.
FHSS
of channels.
STEPS:
Confirm you are currently using the
proper model memory (Ex: 1)
Open the menu, then open PARAMETER
submenu.
Go to RX and change setting.
Cycle power.
Now that the model is in the proper modulation, the T8J should communicate
Change MODEL TYPE to airplane/helicopter: see p. 30.
Set F/S settings for when 2.4G receiver sees interference: see p. 48.
Utilize servo REVERSE : see p. 35.
Adjust servo travel with END POINT : see p. 36.
Set up dual/triple rates and exponential ( D/R , EXP ): see p. 39.
INPUTS:
number on top left and the modulation
on top right. If it is not the correct
model, use MODEL SELECT , p. 27.
for 1 second.
to PARAMETER .
to RX .
cycle power
Cycle power.
31
to FHSS .