FUTABA T8J-2.4G Instruction Manual page 41

GOAL of EXAMPLE:
Set up aileron triple rates on SWITCH
C
aerobatics) and exponential settings of
ACRO model.
N O T E : T h i s n o r m a l r a t e h a s n o
exponential so it has a very linear,
normal feel. This slow roll rate has
positive exponential (the opposite of
what most people normally use), which
feel the same around center in the
normal and low rates, but still gives a
The 3D rate (extreme aerobatics) has a
very high distance of travel nearly twice
that of the normal rate. Therefore, using
a very high negative exponential setting
softens how the servos respond around
for a more comfortable feel.
switch. To do so, simply set up rates
for all 3 controls and assign all 3 to the
Where next?
STEPS:
Open D/R , EXP function.
Choose the channel to change
(Ex: aileron is already selected)
Confirm switch is in desired position
Move SWITCH to 2nd rate position and
set this particular rate.
EXP .
Close.
Set up TRAINER functions: see p. 44.
Adjust the sensitivity of the trims: see p. 45.
Set up twin aileron servos: see p. 52.
Set up twin elevator servos: see p. 54.
INPUTS:
for 1 second.
to D/R , EXP .
to desired channel.
to SW .
to D/R .
C to up position.
AILERON STICK.
AILERON STICK.
C to center position.
AILERON STICK.
AILERON STICK.
C to down position.
AILERON STICK.
AILERON STICK.
to EXP .
C to up position.
EXP reads 0.
C to down position.
AILERON STICK.
AILERON STICK.
C to center position.
41
to SwC .