FUTABA T8J-2.4G Instruction Manual page 90

Expert Tip: Mounting the governor to the counter gear instead of the fan
directly is simpler.
Governor Speed
RS2: 1400
RS3: 1700
*The relationship of the governor speed setting rS1~rS3 and the switch positions conforms to the table above.
*If the speed value rises when the cut switch is activated, reverse the " DIR
GOAL of EXAMPLE:
b o t h c h a n n e l s i n t o t h e r e c e i v e r
and switch between the governor
settings automatically when changing
conditions. Consider setting the battery
Where next?
BPS-1 RPM Sensor which attaches a sensor to an exclusive engine
Switch Position
(Switch C
UP or NORM
CNTR or IDL1
DOWN or IDL2
STEPS:
O p e n a n d a c t i v a t e t h e GOVERNOR
function.
Activate the function.
Ex: select switch that adjusts the
Adjust governor speed settings per
switch position or condition as needed.
(Ex: defaults are fine.) Allows head
speed adjustment from transmitter.
Close the function.
GYRO : see p. 87.
See p. 78.
Adjust elevator/aileron response to fit your flying style: see D/R , EXP and END
POINT / SWASH AFR : p. 39, 36, 75.
Rate (%)
0
50
100
UP to DOWN or vice versa.
F/S ) settings (p. 48).
90
Speed adjusted by raising and lowering rate.
Speed adjusted by lowering rate.
INPUTS:
for 1 second.
to GOVERNOR .
to MIX . to CH7 .
MIX
SWITCH.
to MODE .
to Cond .
to each Cond position.
or as needed.
to next Cond position. Repeat.
to CH7 .
SW . to desired