FUTABA T8J-2.4G Instruction Manual page 63

Where next?
Throttle delay function THR-DELAY ( ACRO ):
GOAL of EXAMPLE:
Activate THR-DELAY
Slow the servo response by one second.
Where next?
Set up THROTTLE DELAY
Adjust throttle and Ch8 END POINTs : see p. 36.
Set up programmable mixes, for example, AILERON-to-RUDDER : see p. 65.
The THR-DELAY function is used to slow the response of the throttle servo to
simulate the slow response of a turbine engine. A 40% delay setting corresponds
THR ), throttle into an auxiliary channel such as 8, and then using
STEPS:
Open the THR-DELAY function.
Activate the function.
Adjust the RATE to match the desired
servo speed. (Ex: 40% .)
Close menu.
Set up THROTTLE-NEEDLE mixing: see p. 62.
END POINT : see p. 36.
Adjust throttle exponential ( D/R , EXP ): see p. 39.
Set up AILEVATOR : see p. 54.
Set up programmable mixes, for example, RUDDER-AILERON : see p. 65.
100%
DELAYS , p. 84.
INPUTS:
for 1 second.
to THR-DELAY .
to MIX .
to RATE .
63
to ACT .
to 40% .