Graco LineLazer IV 250SPS Installation And Operation Manual page 8

200HS Pressurized Bead System Kit 16R955
11. Snug all four nuts down then back the nuts off 1/4
turn. Bracket KK should slide in the slots with some
effort.
12. Loosely install two screws (MM) and two locknuts
(NN) through bottom of frame mount but do not
tighten. Remove existing gun arm bracket to gain
access to nut (NN). NOTE: See "Compressor Align-
ment (200HS)" on page 8.
ti21201a
13. Assemble hopper basket (XX) and base with hard-
ware as shown below. Use 9/16 in. wrench to snug
screws. Loosen all six screws 1/4 turn.
XX
Compressor Alignment (200HS)
Install Compressor Assembly
1. Position compressor (RR) and bracket assembly
(SS) on frame. Install four screws (VV), snug all four
screws down then back the screws off 1/4 turn.
8
MM
NN
ti21194a
ti24337a
0.80 +/- 0.050
Maintain gap set at factory
2. Move compressor and mounting bracket up to the
chain coupler on the mounting plate so that the two
sprockets contact each other.
3. Move compressor assembly up or down (vertical)
and left or right (horizontal) until the compressor is
aligned with the hydraulic pump.
ti24339a
ti24386a
332230G